Skip to Content
Last modified by robert on 2025/07/16 16:40
From version 61.1
edited by robert
on 2025/07/16 16:21
Change comment: There is no comment for this version
To version 60.4
edited by robert
on 2025/07/16 16:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -11,6 +11,7 @@
11 11  
12 12  Both have a battery capacity of around 30 days. The programming, operation, and downloading procedures for both types of SmartSolo nodes are also similar.
13 13  
14 +
14 14  ----
15 15  
16 16  = **Programming Defaults** =
... ... @@ -19,6 +19,7 @@
19 19  
20 20  **Note that this gain must be removed when exporting to miniseed, **otherwise amplitudes will be a factor of either 15.84893192 (24db) or 2 (6db) too high. We also recommend disabling bluetooth to increase battery life, and to enable "FIFO" mode just in case old data is still present on the units and you run out of space (although it is unlikely you will go over 64 Gb for one deploy). If using the "timed turn-on" option, please be aware that **the units will not begin recording until they have acquired a GPS lock**, which may nor occur if they are buried too deeply or have very poor sky view.
21 21  
23 +
22 22  = **Fieldwork Preparation** =
23 23  
24 24  (% class="box infomessage" %)
... ... @@ -43,7 +43,7 @@
43 43  
44 44  = **Installation** =
45 45  
46 -== 1. Logbook documentation ~*~** TODO ADD LOGBOOK FORMS ==
48 +== 1. Logbook documentation ==
47 47  
48 48  (((
49 49  **Essential Details**: Record the following in a logbook:
... ... @@ -245,9 +245,9 @@
245 245  * Click “prepare” followed by “run” to start reformatting. Monitor this process in the small panel at the bottom left.
246 246  * (% class="box warningmessage" %)
247 247  (((
248 -* **Ensure to export data as "COUNTS" (int32), not "mV" (float). This is critical!**
250 +* **Ensure to export data as "COUNTS", not "mV".**
249 249  
250 -* **Set "Remove Gain" to the same decibel gain as during programming. By default ANU sets this to 24db for short period nodes (a scaling factor of 15.848932), and 6db (a factor of 2.0) for broadband nodes.**
252 +* **Set "Remove Gain" to the same decibel gain as during programming** **(by default ANU sets this to 24db for short period nodes (a factor of 15.848932), and 6db for broadband nodes).**
251 251  )))
252 252  )))
253 253  
... ... @@ -268,7 +268,6 @@
268 268  * **Use fast external hard drives to avoid limitations in data harvesting.**
269 269  
270 270  * **Recommended specifications: USB-C, USB 3.0, and 4+ Tb of space.**
271 -* **The USB type for the harvester is TYPE-A, the typical normal rectangular shape.**
272 272  )))
273 273  )))
274 274  1. (((