Skip to Content
Last modified by robert on 2026/06/29 16:42
From version 110.6
edited by Jack Dent
on 2026/06/15 10:07
Change comment: (Autosaved)
To version 110.2
edited by Jack Dent
on 2026/06/15 09:47
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -320,17 +320,16 @@
320 320  
321 321  * Go to the “Tool” menu and select “export seismic data”.
322 322  * Tailor other parameters to project preference and ensure "Sample Interval" matches the setting used during node reset.
323 +* **Ensure export data is set to "COUNTS" (int32), not "mV" (float). This is critical!**
324 +* Set "Remove Gain" to the same decibel gain as during programming. By default ANU sets this to 24db for short period nodes (a scaling factor of 15.848932), and 6db (a factor of 2.0) for broadband nodes.
325 +Set 'Remove DC' to 'Yes' to centre the data around the zero value
326 +Set the correct Start Time (UTC) and End Time (UTC) of the project to prevent the unnecessary export of older data
327 +* [[image:Smartsolo harvesting #9 copy.png]]
323 323  * (% class="box warningmessage" %)
324 324  (((
325 -**Ensure export data is set to "COUNTS" (int32), not "mV" (float). This is critical!**
330 +
331 +)))Click “prepare” followed by “run” to start reformatting. Monitor this process in the small panel at the bottom left.
326 326  )))
327 -* Set "Remove Gain" to the same decibel gain as during programming. By default ANU sets this to 24db for short period nodes (a scaling factor of 15.848932), and 6db (a factor of 2.0) for broadband nodes.
328 -* Set 'Remove DC' to 'Yes' to centre the data around the zero value
329 -* Set the correct Start Time (UTC) and End Time (UTC) of the project to prevent the unnecessary export of older data
330 -* [[image:Smartsolo harvesting #9 copy.png]]
331 -* Click “prepare” followed by “run” to start reformatting. Monitor this process in the small panel at the bottom left.
332 -* The data will be exported to the SOLODATA folder. For a windows system, the following file explorer page is where you must navigate to to locate your project folder
333 -)))
334 334  
335 335  == Smart Solo IGU-16HR Polarity Notice ==
336 336